Note: The following procedure may or may not require the removal of the inlet and or discharge hose(s) and wiring depending on how the unit was installed.

Tip: Operating the unit's dry bowl mode prior to removal, will help minimize water spillage.

Removal

1.) To access the integral inlet pump on model A5 and A6. Remove mounting fasteners at front of unit.

2.) Disconnect hoses and wire in rear of unit and noting their position.

3.) Turn unit upside down on safe surface.

Disconnect the positive and negative intake pump wires from the fuse block and grounding lug.

4.) Turn unit over and face backside of unit.

Disconnect hose at pump outlet and hose to pump intake.

Remove mount support bolts (2) and carefully remove pump and motor assembly from the rear of the toilet.