Page 2 - Raritan FreshHead Owners Manual L524-v1016

OPERATION
OPERATION\CLEANING
1. Check to be sure handle is not in the locked Fig. 1
position (Fig 4).
2. Press rinse water lever to wet the bowl before
use (Fig 2). Rinse lever
3. Pump waste out using telescopic handle,
move handle fully front to back slowly until
all waste is evacuated from bowl. Lock
Note: When pumping solids it is normal for a
few strokes to feel soft until solids clear the
flapper valve.
4. Press rinse water lever
5. Repeat step 3 and 4 as needed.
6. If leaving the boat for extended time, lock the
handle to prevent back flow.
• No special toilet paper is required. Fig. 2 Rinse water lever
Press down
• Hard objects or stringy substances (paper
towels, feminine hygiene products, filter
cigarettes, etc.) must not be thrown into the
toilet as they will cause damage.
• Always shut off seacock(s) and pressurized
water valve before leaving the boat unattended.

WARNING: Discharge pump locking seal is not Fig. 3
intended to prevent flooding.
If difficult to pump, see troubleshooting. Flush handle,
Using excessive force on pump handle will telescopic
damage pump and void warranty.
Cleaning Instructions

IMPORTANT: Do not use cleaners that Fig. 4
contain ammonia, ethyl acetate, phosphoric
acid or concentrated chlorine bleach. These UNLOCK
may cause damage to the toilet.
Using C.P. a bio-enzymatic toilet bowl cleaner
(available from Raritan Engineering Part#
1PCP22) will keep the bowl clean and fresh LOCK
smelling.
Do not use abrasive cleaners or cleaning pads.

Recommend Visual Inspection
For leaks at toilet and hose connections

a Hose clamps
a Condition of hoses
a Seacocks

a In-Line Strainer (if you have one)
MAINTENANCE
®
Super Lube is a registered trademark of Synco Chemical Corp. 2 L524 1016jlc
2