Page 8 - Raritan Hold-N-Treat Electroscan EST System L372v0717
P. 8
WIRING WARNING: Hazard of Shock and Fire Before turning on power, make sure that
WIRING
treatment tank is full of salt water.
• Always use proper wire, wire connectors and
fuse/circuit breaker. See Specification Chart.
• Secure wire properly.
• Do not connect other appliances to electro
scan circuit.
Loosen Screws
Knock
• Make sure power is off before proceeding.
Outs
Electro Scan
• Improper wiring can damage the Circuit
Board and void warranty.
Treatment Unit Control Unit
1. Determine proper wire size from wire chart
on specifications page. START UP
2. Run supply wire from battery NEG to 1. Start with empty holding tank. If tank is not
Negative (NEG) terminal on Treatment tank. empty , power up macerator motor to empty
NOTE:Do not connect supply POS to treatment tank.
tank, connect to control unit. To run macerator/tranfer pump only
Control Box 1 Set the mode to MANUAL
NOTE: Future access to control box is imperative. 2 Press start stop button to start sytem
If unit is installed in an area where access will with pump
be difficult contact Raritan for instructions on 3 After macerator pump stops, prees start/
mounting the control box for distance more stop again to to stop system
than two feet. 4 Repeat steps 2 &3 several times to
1. Run supply Positive (POS) to control unit empty tank
2. Fuse or circuit breaker must be installed
between source and electro scan on positive 2. For system used with fresh water only:
wire. Remove cross over cap from Electro Scan
3. Connect wiring harness between treatment treatment tank and add seawater salinity
tank and control box. Control box side is salt water to the Electro Scan tretament tank.
marked with wire identification and colors. Each gallon of water must contain 4 oz. by
4. Connect wiring harness from level sensor/ weight of salt for seawater salinity. or
macerator pump as per wiring diagram to I/O 3. Turn on power, check the mode and change
board on the control unit. Connect Red wire w if needed
/fuse to positive terminal on the control unit. 4. Use status panel start button to run one cycle
Feed wires thru side holes (knockout) and (MANUAL MODE)without error or warn-
connect to ext trig, man in, and Aux terminal ings. If any error or warning refer to Electro
per color marked on wiring diagram. Scan manual troubleshooting section.
System Status Panel Note: if salt is not added in step 2 , unit will
1. Connect cable from System Status Panel to give error for low amps for two or three
panel 1 jack on Control Unit. cycles before salt feed system feed enough
2. Secure cable strain relief. salt in the system.
LCD Display 5. Start using toilets.
1. Connect cable from LCD Display to display
jack on the Control Unit.
2. Secure cable strain relief.
8 L372 0717jlc
8
